You can control the MASCHINE plug-in and Host Transport when the device is in MASCHINE mode. Your MASCHINE controller is now configured to use the transport controls in Studio One. Use the following table to find the right selection for your device: Note: Depending on your MASCHINE Controller model and Operating System, the selections seen above will vary. Click OK to close the Add Device and Preferences windows.In this example, Maschine Plus Virtual is selected in both fields. To the right of this window, select your MASCHINE Controller in both the Receive From and Send To drop-menus.Click ADD, and use the pop-up window to select Mackie > Control from the folders list.Go to the Studio One Preferences > External Devices.Launch Studio One and insert MASCHINE as an Instrument plug-in.Configuring Studio One for Host Transport Control Quit Controller Editor once the configuration is complete.ΔΆ.Note: This only applies to some MASCHINE Controller models. The Type must be set to MCU Button and its Parameter ID must be 95 ( Record). If it's labeled Off, go to Assign > Type. Click to highlight the area representing the REC button. Check the template to verify that the REC button is assigned.Enable Host Transport Control by ticking its check box.Note: MASCHINE JAM Users can choose Mackie Control Light or MCU Transport. Load the Mackie Control template from the Factory Templates drop-down menu.Choose the first entry for your MASCHINE Controller model here. Note: In this example, MASCHINE+ is used. It will be recognized by Controller Editor if Connect is highlighted. Make sure your MASCHINE Controller is active or powered on. Connect your MASCHINE Controller and open the Controller Editor application.Configuring the MASCHINE Controller for Host Transport Control This article explains how to set up your MASCHINE controller to use the transport controls ( Play, Rec, Stop, etc.) in PreSonus Studio One.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |